Final Assesment Instructions

Step 1: The Back Section  

1.       First Section the hair from just slightly behind the ear and bring to the front to clip out of the way ( this hair will previously be crimped)

2.       Taking the back section using the pin tail comb section the hair diagonally across the head leaving an even amount of hair on each side, with the bottom section clip out of the way.

3.       Starting from the far right hand side of the head begin to French plait following around the side of the head and bringing around at the bottom making sure the hair is pulled tight at each section.

4.       When the hair has run out in the first section begin to take hair from the other diagonal section you had clipped out the way tip the head down and plait upwards to the crown of the head.

5.       When the hair had run out keep plaiting then tie off with a clear band and pin into place making sure all pins are hidden.

Step 2: The Triangular Props.

1.       Middle part the front section.

2.       Taking the previously crimped hair plait two small anchors for the prop to sit on towards the front of the head near the ear, and pin into place.

3.       Pin the prop to the plait with the bun pins securely into place.

4.       Back comb the back of the hair that will cover the prop, place the hair over till the prop is covered and pin into place at the back.

5.       If there is and loose hairs that are too small to pin pull out of the way to the back that will be hidden by the fringe.

6.       Hair spray fully!

Step 3: Finalizing- accessories

1.       Clip the fringe at the crown of the head in the section that the head band will sit on top.

2.       Apply all diamonds to the front structure being careful not to knock the props, and apply the leaf to the middle of the head pinning into place.

3.       Put the head band onto the middle of the head and pin into place to stop slipping. Again hair spray the whole structure. Make sure all pins are hidden.